bermyown.blogg.se

Nissan 300zx ecu diagnostic
Nissan 300zx ecu diagnostic












nissan 300zx ecu diagnostic
  1. #NISSAN 300ZX ECU DIAGNOSTIC CODE#
  2. #NISSAN 300ZX ECU DIAGNOSTIC LICENSE#

Headlamps LO 10 seconds → HI ON-OFF 5 timesĦ.

#NISSAN 300ZX ECU DIAGNOSTIC LICENSE#

Tail lamps, front fog lamps, parking lamps, license plate lamps 10 secondsĤ. Front wiper LO 5 seconds → HI 5 secondsģ. 
NOTE: 
When auto active test mode has to be cancelled halfway, turn ignition switch OFF.

nissan 300zx ecu diagnostic

After a series of operations is repeated three times, auto active test is completed. When auto active test mode is actuated, oil pressure warning lamp starts blinking.ħ. Turn ignition switch ON within 10 seconds after ignition switch OFF.Ħ. Turn ignition switch ON and, within 20 seconds, press driver's door switch 10 times (The door sensor switch in the arch).ĥ. Close hood and All doors except drivers, and then lift wiper arms away from windshield (to prevent glass damage by wiper operation).ģ. €¨â€“ *Tail lamps, front fog lamps, parking lamps and license plate lampsġ. Â- In auto active test mode, operation inspection can be performed when IPDM E/R sends a drive signal to the following systems: NOTE: When auto active test is performed with hood opened, sprinkle water on windshield beforehand. IPDM Intelligent Power Distribution Module (the hidden fuse box) Auto Active Test €¨YD25 Also carries out Fuel Pump Learning Value Clearing when codes are cleared by holding down accelerator peddle for 10 seconds in diagnostic mode.

#NISSAN 300ZX ECU DIAGNOSTIC CODE#

To CLEAR the codes you then hold down the accelerator peddle for more than 10 seconds, and confirm code 0-0-0 is displayed. The MIL will flash codes or 0-0-0 for no fault found.Ĩ. Fully release the accelerator pedal.
— ECM has entered to Diagnostic Test Mode II (Self-diagnostic results).ħ. 10 seconds until the MI starts blinking.Ħ. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. Repeat the following procedure quickly five times within 5 seconds.ĥ. Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.Ģ. (Thank you to Kael2001 at )ĭiagnostic Test Mode II (Self-diagnostic Results) - The Peddle Danceġ. I was able to do a memory reset on the audio head unit on my 2012 PF (it was not able to remember clock and mileage settings, they reset each time I restarted the engine - and removing fuses did not help).

nissan 300zx ecu diagnostic

Came across this very informative post on a Nissan Navara user forum.














Nissan 300zx ecu diagnostic